Material removal rate and electrode wear study on the EDM of silicon carbide

(BQ) This study was made only for the finish stages and has been carried out on the influence of five design factors: intensity supplied by the generator of the EDM machine (I), pulse time (ti), duty cycle (η), open-circuit voltage (U) and dielectric flushing pressure (P), over the two previously mentioned response variables. This has been done by means of the technique of design of experiments (DOE), which allows us to carry out the above-mentioned analysis performing a relatively small number of experiments. In this case, a 25−1 fractional factorial design, whose resolution is V, has been selected considering the number of factors considered in the present study.

Từ khóa: Material removal rate, Electrode wear, The EDM of silicon carbide, Silicon carbide, The EDM process